After breaking mine I had Uncle-J build a custom handle for me. It came out great. If you use your handle this horizontal grip is more natural and is really comfortable. This handle is stout and should hold up to the abuse my motor goes through. Made it high enough to help protect the oil cooler and carb from low limbs. Now I just got to get some paint on it. Thanks again to Jason and crew...

Looks good man.

Looks nice. Jacob can do some good work. Hope my grab bar looks that smooth.

How the F did you break your stock one? You need to ease up on all them bicep curls you must be doin to break that MFer off, damn.

It needs some gussets!! It will break mine has broke many times i put gussets all over it!! Also if yall build any more like that use thicker plate were it welds to bolt on plate!! Those handels are the shit though!!

been thinkin about makin some really nice ones on the cnc mill, how tall is that handle from the bottom of the mounting plate?

what oil cooler are you using on top? where did you get it?

I've used the handle to hold onto when working the motor back and forth to dig out, I figured that was why it is a vertical handle. What do you do with it that requires that sort of handle?

Also, what does the little gauge located on the oil filter side of the motor monitor?

Looks like an oil pressure guage.

Good lookin bracket, Poker. Looks like Uncle J Customs is branching out into accessories now. Good deal.

Looks good to me .... I likes them wholes in it ..... gives you a good place to tie Skwerrll tails to .... Thats a problem I gots with mines Gator-Tail ..... just ain't really a place to tie them tails too ......

Got it...Thanks!