Author |
Message |
2007CHEVY
MMT Member
Joined: Sun Sep 04, 2011 4:48 pm Posts: 8
|
 pd running like shit! please help!!!
I have a bone stock pd 32 thats been running like shit and now doesn't start at all. It would spit and sputter and die at wot then start hard and run like crap again. it would run with minimal missing in the driveway but under load in the water it dies.checked and cleaned carb and it seems good to go. put new plugs in and checked spark. There seems to be spark but i noticed the test light is much dimmer when hooked up between the plug and wire than if i grounded it to the block.also checked fuel filters and for air leaks in the fuel line and it all looks good too. I pulled the valve covers and checked valves and those check out also. so i think i covered the basics but cant figure it out. any pointers would be much appreciated. thanks.
|
Fri Sep 23, 2011 9:11 pm |
|
 |
Wilson
MMT F.E.
Joined: Thu Jan 15, 2009 6:35 pm Posts: 935 Location: South LA
|
 Re: pd running like shit! please help!!!
Could be your diodes? Are you getting good spark on both cylinders?
|
Fri Sep 23, 2011 10:59 pm |
|
 |
russellm454
MMT Pro Member
Joined: Fri Nov 05, 2010 11:23 pm Posts: 216
|
 Re: pd running like shit! please help!!!
How old is the fuel you may have water in it.
|
Fri Sep 23, 2011 11:05 pm |
|
 |
2007CHEVY
MMT Member
Joined: Sun Sep 04, 2011 4:48 pm Posts: 8
|
 Re: pd running like shit! please help!!!
its fresh 91 in the tank. so the gas should be ok. Where would i find the diodes and how do i test them. The spark seems weak on both cylinders.
|
Sat Sep 24, 2011 6:26 am |
|
 |
postalpaul
MMT 1000 Club
Joined: Sun Nov 01, 2009 6:25 pm Posts: 1935 Location: Kaufman- TEXAS
|
 Re: pd running like shit! please help!!!
Compression check is also needed
|
Sat Sep 24, 2011 7:24 am |
|
 |
richard nagon
MMT Addict
Joined: Wed Apr 20, 2011 5:35 pm Posts: 537
|
 Re: pd running like shit! please help!!!
a test light is not a good way of testing spark. go buy a spark tester. try misting your carb with some carb cleaner. not a direct spray just a mist if it trys to start i would think that you have a dirty carb which than you will need to do a complete cleaning. you can test diodes with a volt ohm meter that has a diode test feature. but thats not your problem just my thoughts.
_________________ JUST ANOTHER FARMER ON WELFARE
|
Sat Sep 24, 2011 7:47 am |
|
 |
deadbird8
MMT 1000 Club
Joined: Wed Feb 04, 2009 7:50 pm Posts: 3833 Location: Old East Dallas, Texas
|
 Re: pd running like shit! please help!!!
Diodes are on the wiring harness going to the coils- its the control wire that grounds the coils when key is turned off or kill switch is pulled. When a diode fails, that coil will not fire. I agree that the wiring harness is probably not your problem.
_________________ Excel 1851F4 w/ MB35HD+R CDI with a little bit of this and little bit of that
|
Sat Sep 24, 2011 8:16 am |
|
 |
pokey79
MMT 1000 Club
Joined: Mon Nov 15, 2010 4:50 pm Posts: 2282 Location: Circumcised, Louisiana
|
 Re: pd running like shit! please help!!!
make sure ur choke isn't stuck in the on postion too!!!
|
Sat Sep 24, 2011 9:00 am |
|
 |
2007CHEVY
MMT Member
Joined: Sun Sep 04, 2011 4:48 pm Posts: 8
|
 Re: pd running like shit! please help!!!
Thanks for the suggestions. A repair guy nearby said that an electric fuel pump is the way to go so maybe thats the problem. Thanks
|
Sat Sep 24, 2011 9:13 am |
|
 |
2007CHEVY
MMT Member
Joined: Sun Sep 04, 2011 4:48 pm Posts: 8
|
 Re: pd running like shit! please help!!!
Runs like a champ now. Turns out it was a wire between the coils that had rubbed bare. bad placement from factory. I just cut out the bad section and pieced in a new one. good as new. Hopefully this helps out someone if you ever have the same kind of problem. Thanks again everyone.
|
Sat Sep 24, 2011 3:20 pm |
|
 |
|