I've noticed when I run across dry land or something of the sort that will kick your motor up. Well for a while now when if kicks up good it tends to stay up and I have to nudge with my butt back down. Well about half the time I push it back down I flip it into neutral. Not the best then went goin across shallow hard bottom. Was wondering if I can do something so that when it kicks up it'll good back down by itself.

Don't butt hump it. Reach back and push it down

That all depends on were your trim is located !! Get the box upgrade will move everything to your handle

Also that custom handle Terry has on his single gtr is pretty cool.

Couple shots here... viewtopic.php?f=5&t=6817&start=0

Well usually one had on filler and one hand grab bar don't like take the risk of taking hand off the grab bar though. But any input of what I can do without spending money

Maybe grease that Mofo?

I haven't had that problem, mine falls back into place by itself.

I also upgraded to the control box on the handle as previously mentioned. The main reason i did this is because there are no crappy relays with the new control box. I haven't had any trim issues since.

Nfw what kind of boat you run!! Reason I ask if the transom angle is less it will change the pivot point

He has a gator tail hull.

Got damn son your hit seomthing hard for it to kick up and stay up, lmao thats wild, X2 ddm with th transom angle

Ok what hole are you running on it!! I notice mine does it slot Aldo but only when it's trimmed up high!! It will do it alot if it's on the top hole!!

Just the middle hole. Idk it just get real annoying when it stays up cause that the cause of me gettin stuck like 90% of the time.