When putting a mikuni on with a rev box the govenor gear isnt needed correct?? The reason im asking i just did new rods and pistons amd crank and the governor gear came apart in the motor put a bunch of metal in my motor and destroyed new high performance rods and crank... i dont want this happening again and wanted to double check to make sure its ok to run them without

You don't need it

I would take all the gears on the crankcase cover out.

O its been removed came out in about 30 peice it was doing good cody ran 35 at 4900 rpm and 30 at 4100 with 2 people and a dog guess im gonna go back with the 31 setup if i dont like it im gonna beef it back up

Sounds like you learned the hard way.

Uhh yea didnt have a lot of money n evt rods n crank but alot of time trying get everythibg together to make it right amd with a bunch of help from cody and rod i got it all right... well for 3 hours of running at least