The ole rope-a-dope

His comment just goes back to saying everyone's stage motors are not all the same, most say Cam, heads and exahaust is a stage 1, cam-heads-exhaust and carb is a stage 2, cam-heads-carb-rods-pistons-exhaust is an extreme stage 2 lol stage 3 is getting into milling the block

Well of he pays my gatortail bill since it was his mistake that caused me to replace a piston rod, crank, gaskets,oil etc twice.. 70 hrs on my engine it's had 5 oil changes in the past ten hours on it but it run likea sumbeach now

Here we go...

Sent from my SCH-I545 using Tapatalk

THis shit just got real! MAAAAAAAAA MEAT LOAF FUCK

AKA it's a good thing your transom is 21" now, if it was still 16 for the old GD you might get swamped by a democratic rogue wave

So before we get off topic and I have to whip a old democrat lover who actually done the Headwork on ur motor ak. And what did it actually look like


Sent from the baddest mudmotor out there

Dem fukrs rite dare look like my 8 year old got a hold of my sallssaw and a chizle and hammer


Sent from the baddest mudmotor out there

I dont know what your point is with those pics is that a result of his work?

Yeah....if that's supposed to be polished, there is a lot to be desired


Sent using Morse Code from my not so smart phone.

All polishing does is sell heads to people that don't know any better. It's about size and shape. Whoever did those heads is leaving a lot of power on the table.

For those saying you are sure he will make it right and it's a miscommunication you are right on one part. He FAILED to communicate to me about getting something different. When I approached him about the restocking fee the first story was "the 45 would've worked fine". Well, I didn't order a 45 I wanted a 42. That changed his story to " well I told you I was sending a 45 you just don't remember". Bullshit that convo NEVER happened. So then he said "I have to pay to send it back to BPS since you changed your mind". Bullshit I never changed my mind, I returned the item I didn't order. And I doubt he sent it back to BPS, probably sent it right along to the next guy like he did with me. So ten the story is "you ordered a bps kit and that's what you got, sorry bout your luck go fuck yourself" in so many words. That guy can eat a bag of dicks.

I bought a 45 from Calen before the season. He set it up with the optimum needles. Haven't installed it yet. I knew exactly what I was getting and I believe Rod (AKA Team Camo) would have informed the OP of this as well.

Maybe thats why Dguidry thinks he a great guy, he has Rob, mixed up with Rod….or he's just dyslexic.

Maybe rob hired him as legal representation b/c shit is starting to hit the fan

I believe that has been established already

U th?

Fingers got a little ahead of me

ddm syndrome

Just buy your Mikuni carbs from amazon. Replace the needle and seat, replace the main jet and buy the couple little bullshit parts on your own. You will save a bunch of money! I paid under 300$ for my 42mm Mikuni and a total of under 500$ for everything I needed to install the carb. If you are doing all the mods yourself then you should be able to make up this bullshit kit yourself.

Team Camo built my motor and am more that happy.