Got the new Mikuni in. Got her put on. the throttle response is awesome and I can feel an obvious difference in how fast the RPMs get up. The only problem is i cant figure out how to wire the Rev limiter. The directions are telling me to splice wires that arent there. Green/ Grey??????? Any suggestions

Not sure which kit you are using and you didn't post what motor you are putting it on.

Here is a MB wiring diagram for a 35 that may help out on where the connections are. Green jumped to the black on the key switch, white to the 15A ckt breaker, black to ground at the starter.

http://www.mudbuddy.com/_includes/MB%20 ... 206000.pdf

Sorry That would be helpful. Its a PD 36 and a BPS kit

I have that set up on a 32 PD and your right, the pics were a little confusing with inconsistent wire color. Call Jim at All mud motors.com and have him email you the diagram. I had trouble too, at first, but worked thru it. I can't remember off hand to tell you. Also, ditch the braided throttle cable with that kit, it is $hit. Get one from EVT. It is a solid cable and I like the way it is routed better.

dont even put it on its going to go out or give you problems anyway.

Thanks guys! I run timber, NASTY TIMBER! I need something to protect the carb and filter, it is getting demolished already. any ideas?