Author |
Message |
cajun1085
MMT Pro Member
Joined: Fri May 10, 2013 2:57 pm Posts: 183 Location: Silver Spring, MD
|
 Deploying, motor is going to sit....
Gentlemen, looks like I will be leaving in August/Sept for 6-9months. Other than draining all the fuel. Is there anything else y'all suggest I should do to set the motor up for that time?
_________________ GTB 1646 w/HD, Boat Blind-25GTR
SOUTHEAST GATORTAIL
|
Fri May 23, 2014 10:57 am |
|
 |
BoatDR
MMT Sponsor
Joined: Tue May 24, 2011 6:43 am Posts: 1604
|
 Re: Deploying, motor is going to sit....
1) thank you for your service.
2) covered storage would be best (garage, carport, etc), but if you dont have access to covered storage, I'd at least get something to cover the motor with.
3) yes draining the entire fuel system would be a good idea, that way you can start over fresh when you get back. Other than that, spray the motor down with a good anti corrosion spray (especially the wire connections).
4) I would also unhook the battery. And would be a good idea to put a good charge on it before you leave too.
5) when you get back, I would then change all the fluids and lubricate everything before you put her back on the water.
6) be safe on your deployment, and hope you make it back in time to do a little hunting.
|
Fri May 23, 2014 11:02 am |
|
 |
baron von
MMT 1000 Club
Joined: Tue Jan 21, 2014 2:52 pm Posts: 2806 Location: Minnesota
|
 Re: Deploying, motor is going to sit....
good luck on your deployment
absolutely if you can I would park inside barn/garage at least covered.
I also take Gatorade bottle(s) with a bunch of holes in them and put moth balls in them to keep mice out of everything. Spread a couple strategically around your boat/motor, those little buggers like to move in to everything.
And for godsake be careful
_________________ that's going itch when it dries
|
Fri May 23, 2014 11:17 am |
|
 |
cajun1085
MMT Pro Member
Joined: Fri May 10, 2013 2:57 pm Posts: 183 Location: Silver Spring, MD
|
 Re: Deploying, motor is going to sit....
Thanks for the replies. My boat is kept in the garage all the time. The only time its slept outside is when I go camping haha. I am hoping to make it back for some of turkey season next year.
_________________ GTB 1646 w/HD, Boat Blind-25GTR
SOUTHEAST GATORTAIL
|
Fri May 23, 2014 7:05 pm |
|
 |
baron von
MMT 1000 Club
Joined: Tue Jan 21, 2014 2:52 pm Posts: 2806 Location: Minnesota
|
 Re: Deploying, motor is going to sit....
good luck man
_________________ that's going itch when it dries
|
Fri May 23, 2014 7:57 pm |
|
 |
50fps
MMT 1000 Club
Joined: Tue Jan 13, 2009 6:42 pm Posts: 2377 Location: West Coast Wisconsin
|
 Re: Deploying, motor is going to sit....
Change oil and filter prior to deployment. Dirty oil is acidic and can pit some surfaces.
|
Sat May 24, 2014 12:35 pm |
|
 |
Puddler45
MMT 1000 Club
Joined: Thu May 03, 2012 9:07 am Posts: 1199 Location: Wisconsin's waters and woods
|
 Re: Deploying, motor is going to sit....
You can use fogging oil spray it into the intake while running then kill engine while spraying until it shuts down. I do this to my snowmobile before spring to keep everything fresh and lubed.
Thanks for your service.
_________________ 1744 floating a 23 MBHD Stage 2
|
Tue May 27, 2014 10:53 pm |
|
 |
Swampnuts
MMT 1000 Club
Joined: Wed Dec 12, 2012 3:12 pm Posts: 1504 Location: St.Amant,LA
|
 Re: Deploying, motor is going to sit....
Thanks for your service, be safe.
_________________ 16X48 WELDBILT -25GTR EFI-sold 18x48 GTB - 35 GTR
Crown royal pro-staff
|
Wed May 28, 2014 6:19 am |
|
 |
|