I am noticing that my Hydraulic reverse is sticking at times. Doesn't seem to have the same torque to turn the lower unit. Some times it works like a champ and other times I hear the hydraulic pump working, but it is not turning the lower unit. I will trim the motor up and then it seems to work fine. Other times it just turns as normal? Any thoughts? Thx for the input. I have a feeling eventually I am going to have this thing in reverse and not able to swing it back around!

You better hope it doesn't stop half way while you are out in the marsh!!You will just be going in circles

It could be one of the 60 hydrolic lines pinched !!LOL

Maybe some air in the lines.

Very helpful guys!

The best advice-- call KP. Sprayed it down with some lithium grease. Will see if this loosens things up today. If not, I am guessing it is the hydraulic lines.

I gots to put mines hands on one just this past week-end ... very nice invention Pro-Drive came out with !!! My guess is gonna be air in the lines and I'm shore thay have a way of bleedin' that off. Did you git a manual with the purchace?

I tie it to my wrist on a long rope so that don't happen. Sometimes you just got to be smarter than the magnet.

Damn, I didnt know we was competing.

Poker needs a BIGGER magnet most times cause he still aint found his brush knife!!!

nevermind.

Mr. Brooks,

Would you have some change for dis chump? I am trying to get the manual pin puller, but if racheting with the steering wheel won't work, den hydro it must be:(

Thanks,

the dog