Author |
Message |
sankmymotor
New Member
Joined: Mon Apr 02, 2012 9:16 pm Posts: 2
|
 submerged go-devil PLEASE help!
whats up guys.
hit a stump and sank my boat tonight.. 6.5 go-devil was completely submerged for about five minutes before i pulled it up. I havent tried starting it up yet, I replaced the gas and the oil so far, but still afraid to try and pull start it. what else should i do before i give it a shot?? Is there any hope for me at all?? this motor has been my baby for 5 years.
Thanks alot folks
|
Mon Apr 02, 2012 9:53 pm |
|
 |
bubba777
|
 Re: submerged go-devil PLEASE help!
Crank that baby up
|
Mon Apr 02, 2012 9:55 pm |
|
 |
PaleoHuntr
MMT 1000 Club
Joined: Mon Feb 21, 2011 5:21 pm Posts: 1800 Location: Idaho Falls, ID
|
 Re: submerged go-devil PLEASE help!
Put it in a big bag of uncooked rice 
_________________ 1976 16X48 Lowe powered by a 25hp MB LT and dino turds
To have really lived, you must have almost died. To those who have fought for it, freedom has a flavor the protected will never know.
|
Mon Apr 02, 2012 9:58 pm |
|
 |
lastchance
MMT 1000 Club
Joined: Wed Feb 09, 2011 1:56 pm Posts: 1646 Location: Chauvin
|
 Re: submerged go-devil PLEASE help!
Pull the spark plugs and roll the engine over to make sure there is no water on top of the piston! Thats about all else I can think of! Edit- flush out the carb with fresh fuel also!!
|
Mon Apr 02, 2012 9:59 pm |
|
 |
david95
MMT Addict
Joined: Thu Jan 12, 2012 5:15 pm Posts: 641 Location: Summerville, South Carolina
|
 Re: submerged go-devil PLEASE help!
I did this once with a buddy. Be sure to take plugs out and turn it over a few times until water quits spitting out then put plugs back. Drain the carb and then pump with new gas and crank it for a minute and then shut it off and put new oil in it again and if the oil is still milky keep changing until no more whiteness at all! And that should be it we had to change oil about 6 times but he has a 27. Everything should be fine as long as you change oil and get new plugs.
_________________ 27 GDLT pushing a War Eagle 1542
|
Mon Apr 02, 2012 9:59 pm |
|
 |
chaseh
MMT 1000 Club
Joined: Thu Apr 15, 2010 1:50 pm Posts: 1230 Location: Waco, Texas
|
 submerged go-devil PLEASE help!
Lots of WD40. Pull spark plug make sure there is no water in your cylinders. Water will get everywhere, maybe even shake it around a little. Then replace oil til it's no longer getting lighter. (that's if you missed some water)
EDIT: got errored out of MMT and you bastards beat me to it!
|
Mon Apr 02, 2012 10:23 pm |
|
 |
CCC
MMT 1000 Club
Joined: Sun Jan 01, 2012 9:25 am Posts: 1685
|
 submerged go-devil PLEASE help!
Run diesel through it, pull the plugs and bump it, keep doin it till the water is gone
|
Mon Apr 02, 2012 11:09 pm |
|
 |
Woodiebuster
MMT Elite Member
Joined: Wed Mar 03, 2010 7:00 pm Posts: 6060 Location: Choudrant, La
|
 Re: submerged go-devil PLEASE help!
There is very little to one of these motors at all, you can take it apart with a 7,8,&10mm nut driver basically.
I would 1. Drain the oil and flush it out once or twice. 2. Drain the tank out really well ( I would probly take it off and blow it out with an air compressor) 3. Take off the air filter cover and intake manifold (8mm) to get to the float bowl easier, remove that bolt on the bottom and dry out the carb and bowl (I think it is 5/8 but cant remember off the top of my head) 4. Pull your spark plug off and pull the recoil several times to blow any water out of the cylinder. 5. Give it all time to dry out Re Gas and Oil that bitch and don't look back.
_________________ CSM Custom 18x42 Battleship with a 36 PD beating you to the hole My Rig (Old Motor) viewtopic.php?f=5&t=45193
(New Motor) viewtopic.php?f=5&t=54733 Stumps Fear Me
|
Mon Apr 02, 2012 11:33 pm |
|
 |
Buzz Killington
MMT 1000 Club
Joined: Tue Jan 10, 2012 12:33 pm Posts: 2455
|
 submerged go-devil PLEASE help!
_________________ Support your troops - they support you
B. MacDonald
|
Tue Apr 03, 2012 5:50 am |
|
 |
sankmymotor
New Member
Joined: Mon Apr 02, 2012 9:16 pm Posts: 2
|
 Re: submerged go-devil PLEASE help!
haha thanks yall
|
Tue Apr 03, 2012 8:29 am |
|
 |
CootSlayerRMFT
MMT Elite Member
Joined: Thu Feb 02, 2012 12:53 am Posts: 7565 Location: Prairieville, LA
|
 submerged go-devil PLEASE help!
I'd go with the rice. It worked on my iPhone when this happened... --- I am here: http://maps.google.com/maps?ll=30.714823,-88.105830
|
Tue Apr 03, 2012 9:03 am |
|
 |
CLICKSTER
MMT 1000 Club
Joined: Sat Feb 12, 2011 4:08 pm Posts: 1552
|
 Re: submerged go-devil PLEASE help!
No dont put diesel in it, it will swell the gaskets. thats old school and dumb.
Seafoam it after the first few oil changes. and run some in the fuel.
|
Tue Apr 03, 2012 9:45 am |
|
 |
SwampDonkey1
MMT F.E.
Joined: Tue Mar 08, 2011 10:09 pm Posts: 923 Location: North Central KS
|
 Re: submerged go-devil PLEASE help!
_________________ 1436 Lowe -Workin for the man, Huntin when I can...-
|
Wed Apr 04, 2012 12:40 pm |
|
 |
postalpaul
MMT 1000 Club
Joined: Sun Nov 01, 2009 6:25 pm Posts: 1935 Location: Kaufman- TEXAS
|
 Re: submerged go-devil PLEASE help!
Negative ghost rider change thd oil change the gas and don't look back
"washed" mines three years ago according to COCO
|
Wed Apr 04, 2012 5:25 pm |
|
 |
|